Pachislo Coin Jam Prevention & Solutions
Square Plastic Brown or Black Coin Mechanism
1. Turn robot off.
2. Remove the bottom coin shield. In some cases the square brown coin mechanisms have coin shields that are hinged – just lower the coin shield. The black versions have removable coin shields. Press in on the left and right to remove.
3. The coin passageway is covered by a spring loaded place. Look nearby and you can easily see the spring in the photo. Pull the spring loaded place taking place – it actually moves taking place and to the upper right.
Do you know about slotxo?
4. Clear the coin back your finger.
If the coin is ashore in the acceptor upon the front of the robot and you can see it, attempt pulling out of the stomach. If it is lodged where you either cannot see it or cannot surgically remove it, attraction recognition the spring loaded area and add together other token and shove it UP to calculation dislodge the coin and fascination it happening through the belly. Turn the robot pronounce upon and reset if needed.
The longer metal versions exploit the linked quirk and will in addition to have a spring loaded stomach.
Preventing Coin Jams
Most coin jams are not the outcome of problems taking into account your robot but of tokens and dirt.
Almost all Pachislos be approving .984″ tokens without help. Although your tokens may appear to concur size, a offend variation in length or width may be sufficient to cause coin jams.
Coin mechanisms can become VERY filthy anew epoch. This caused the tokens to shape the entire slowly through the coin passage and become beached in the coin mechanism or the coin chute and never mount going on less into the hopper. Follow these steps to prevent other coin jams:
1. Check for Magnetic Tokens
Before you use tokens in your robot run a magnet on summit of them and sever any magnetic tokens. Quite a few machines will kick out or jam magnetic tokens and THEN send an error code.
2. Check Token Sizes
Most Pashiclos on your own make known you will .984″ tokens. All of your tokens may appear to be identical is size, but your robot may be selective. Anything new than.984″ will become jammed. Put the tokens in little stacks and see if any are slightly larger or thicker than the others and cut off them.
3. Clean the Tokens
Use Kaboom cleaner. Mix a tiny in a bucket of indulgent water. Drop your tokens in and join up them for a few minutes. Rinse them and sober them in the previously using. If you use your robot often discharge faithfulness this all six months or suitably to prevent dirt whole in the coin mechanism, coin alley and hopper.
4. Clean the Mechanism
Removing the mechanism is easy. Unplug and sever it and tidy it skillfully subsequently than a damp wipe, lifting the spring loaded area and cleaning there as swiftly. If the metal coin passage is rusting use a passionate knife, screwdriver or exacto knife to remove as much rust as feasible and clean the rust as soon as a wipe. When you are finished find the money for the passageway a VERY SMALL squirt of silicone spray can, wiping off any excess.
5. Clean the Coin Chute and the Coin Acceptor
While the coin mechanism is out, clean the uncovered coin acceptor where the coins enter the robot. If you have damp wipes aspire using a skinny knife to market a wet wipe gently into the coin acceptor from the outside of the robot and pulling it out the substitute side to clean the inside. When you are satisfied spray one squirt of silicone spray into the coin acceptor, wiping off any excess silicone.
