Pachislo Coin Jam Prevention & Solutions
Square Plastic Brown or Black Coin Mechanism
1. Turn robot off.
2. Remove the bottom coin shield. In some cases the square brown coin mechanisms have coin shields that are hinged – just humiliate the coin shield. The black versions have removable coin shields. Press in regarding the left and right to cut off.
3. The coin passageway is covered by a spring loaded area. Look closely and you can easily see the spring in the photo. Pull the spring loaded area happening – it actually moves going on and to the upper right.
4. Clear the coin behind your finger.
If the coin is beached in the acceptor by now insinuation before of the robot and you can see it, attempt pulling out of the belly. If it is lodged where you either cannot see it or cannot cut off it, draw door the spring loaded area and put in jarring token and shove it UP to shove dislodge the coin and draw it happening through the stomach. Turn the robot by now occurring upon and reset if needed. Do you know about PG SLOT?
The longer metal versions produce an effect the same mannerism and will as well as have a spring loaded front.
Preventing Coin Jams
Most coin jams are not the outcome of problems as soon as your machine but of tokens and dirt.
Almost all Pachislos admit .984″ tokens isolated. Although your tokens may appear to be the thesame size, a insult variation in length or width may be permissible to cause coin jams.
Coin mechanisms can become VERY filthy more than period. This caused the tokens to shape totally slowly through the coin alleyway and become stranded in the coin mechanism or the coin chute and never slip into the hopper. Follow these steps to prevent considering coin jams:
1. Check for Magnetic Tokens
Before you use tokens in your machine inform a magnet on pinnacle of them and cut off any magnetic tokens. Quite a few machines will kick out or jam magnetic tokens and THEN send an disaster code.
2. Check Token Sizes
Most Pashiclos single-handedly certify .984″ tokens. All of your tokens may appear to be identical is size, but your machine may be selective. Anything added than.984″ will become jammed. Put the tokens in small stacks and see if any are slightly larger or thicker than the others and surgically remove them.
3. Clean the Tokens
Use Kaboom cleaner. Mix a tiny in a pail of hot water. Drop your tokens in and merger them for a few minutes. Rinse them and ascetic them previously using. If you use your machine often get hold of this all six months or so to prevent dirt accretion in the coin mechanism, coin alley and hopper.
4. Clean the Mechanism
Removing the mechanism is easy. Unplug and cut off it and tidy it quickly bearing in mind than a damp wipe, lifting the spring loaded area and cleaning there as adeptly. If the metal coin passageway is rusting use a sensitive knife, screwdriver or exacto knife to surgically cut off as much rust as realizable and tidy the rust plus a wipe. When you are ended assign the passage a VERY SMALL squirt of silicone spray can can, wiping off any excess.
5. Clean the Coin Chute and the Coin Acceptor
While the coin mechanism is out, tidy the outdoor coin acceptor where the coins enter the machine. If you have damp wipes attempt using a skinny knife to adding together a damp wipe gently into the coin acceptor from the outside of the machine and pulling it out the progression side to clean the inside. When you are satisfied spray one squirt of silicone spray into the coin acceptor, wiping off any excess silicone.